Loading... Please wait...

ASI 502 100% INDUSTRIAL SILICONE SEALANT

  • Image 1
Price:
$5.25
Brand:
ASI
Shipping:
Calculated at checkout
Quantity:


Product Description

Buy a case and save!

ASI 502 Industrial Silicone Sealant/Adhesive is a one-part, moisture-curing RTV (room temperature vulcanizing) silicone that cures to a strong, silicone rubber that maintains long-term durability and flexibility. ASI 502 is a non-slump sealant and can be applied to vertical or overhead surfaces without flowing or sagging.Because ASI 502 is a 100% silicone sealant, it has excellent resistance to weathering including ozone, ultra-violet radiation, freeze-thaw conditions and airborne chemicals. Fully cured, ASI 502 has excellent adhesion to glass, metal, porcelain, ceramic, wood, most plastics and many other nonporous substrates. ASI 502 can be applied to surface temperatures from -18°C to +50°C (0°F to +120°F) and after curing, withstands constant operating temperatures from -57° to +233 (-70° F to 450°F.

Typical Uses

ASI 502 is an excellent sealant and/or adhesive for many industrial applications where a long-term, permanently flexible bond or seal is required. Such applications include:

  • formed-in-place gaskets for axle housings, differentials, junction box covers, etc.
  • adhering appliance trim and sealing appliance parts
  • adhering name plates, letters and signs
  • sealing joints in ductwork
  • sealing truck trailers, cabs, marine portholes and cabins
  • sheet metal
  • skylights
  • Sealing aquariums

 General Sealing:  Food service installations, walk-in refrigerators, trailers, engine components, seal and waterproof, coaxial cable connectors, weatherize switch parts and instrument mountings.

Directions

ASI 502 is ready to use and requires no mixing or additives. The cure mechanism begins as soon as the sealant comes in contact with the air. At conditions of 25°C(77°F) and 50% relative humidity, the sealant will skin in 10 minutes and fully cure in 24 hours (1/8 bead) and reaches its maximum adhesion in 7 days. Higher humidity accelerates cure. Tooling, if necessary, should be done before skinning takes place. In applications where partial or total confinement of sealant is prevalent, the time required for proper cure is generally lengthened by the degree of confinement.

Surface Preparation

All surfaces should be clean and dry. It is recommended that bonding surfaces be solvent wiped with naphthas, ketones or chlorinated solvents. Specific solvents would include xylol, toluol and mineral spirits. In case of plastics, determine suitability of solvent prior to use. Allow surface to dry thoroughly before applying sealant. Do not solvent wipe with alcohols or oil-containing solvents such as Varsol.

Priming

Priming for ASI 502 is not normally required for applications to nonporous surfaces. Unprimed adhesion can be easily tested by applying a small trial bead and allowing 7 days for maximum adhesion to occur. If primer is required, contact ASI.

Painting

ASI 502 sealant should not be applied to surfaces that will be painted. Painting over sealant is not recommended because the paint film does not stretch with the extension of the sealant.

FDA Status

ASI 502 is permitted under regulations of the Food and Drug Administration where incidental food contact might be involved. FDA Regulation number is 175.105.


Find Similar Products by Category


Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!


Add to Wish List

Click the button below to add the ASI 502 100% INDUSTRIAL SILICONE SEALANT to your wish list.

You Recently Viewed...